Saarland University
Lehrstuhl für Automatisierungstechnik

Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
> I can simulate kinematic loops without cut-joints, but why???
Rene Nölle
post Jun 26 2009, 10:40 AM
Post #1


Group: Members
Posts: 8
Joined: 3-July 07
Member No.: 1,312


I need some advice regarding the integration process in Dymola/Modelica. There is a complex Model that contains several kinematic loops (not just planar kinematic loops).
I can simulate this model without any error-messages even by using the Newton-Integrator. In addition I have NOT implemented any cut-joints or assembly-joints, to cut the loop.

Therefore I want to figure out how the model is integrated. "Maybe" the process is based on velocities to avoid the kinamtic loops…

Is there some kind of protocol that contains any information concerning the integration process, and where can I find it???

User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:


Lo-Fi Version Time is now: 18th September 2019 - 08:42 PM