Saarland University
Lehrstuhl für Automatisierungstechnik

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> A Resistor with no current flow, P.i = 0 !!!!!
filip jezek
post May 4 2010, 11:19 PM
Post #1


Newbie
*

Group: Members
Posts: 5
Joined: 25-April 10
Member No.: 75,219



so where was the problem?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
MOS701
post Feb 24 2009, 03:44 PM
Post #2


Member
**

Group: Members
Posts: 16
Joined: 11-February 09
Member No.: 30,419



I found the probleme tongue.gif

i am sorry
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
MOS701
post Feb 23 2009, 02:25 PM
Post #3


Member
**

Group: Members
Posts: 16
Joined: 11-February 09
Member No.: 30,419



Hi ,

A new question to Ask tongue.gif,

i am trying to code a voltage depended voltage source, i call is VDCS :

within Diode;

model VDCS
Modelica.Electrical.Analog.Interfaces.Pin P "Positive noeud";
Modelica.Electrical.Analog.Interfaces.Pin N "Negative noeud";
Modelica.Electrical.Analog.Interfaces.Pin C "Command noeud" ;
parameter Modelica.SIunits.Conductance K "Gain parameter";
SI.Current Id;
SI.Voltage VL;
SI.Voltage v ;

equation

Id = P.i;
VL = C.v - P.v;
Id = K * VL ;
0.0 = P.i + N.i;
C.i=0;
v = P.v - N.v;

end VDCS;
normaly the C pin is the command pin (i=0) and VL=C.v-P.v ; i used the P.v to simplify because the P pin is connected to the L.n or R.n pin .

and the test model is the following :

model test_VDCS_resistiveL

Diode.VDCS JC (K=6100);
Modelica.Electrical.Analog.Basic.Ground gnd;
Modelica.Electrical.Analog.Basic.Resistor R(R=5.7e-3);
Modelica.Electrical.Analog.Basic.Resistor RL(R=0.1e-3);
Modelica.Electrical.Analog.Sources.PulseVoltage E(V=10,period = 2.0e-8);

equation
connect(E.p,R.p);
connect(R.p,RL.p);
connect(JC.N,R.p);
connect(JC.P,RL.n);
connect(JC.C,R.n);
connect(E.n,RL.n);
connect(E.n,gnd.p);

end test_VDCS_resistiveL;

the VDCS work properly, i mean the modelica shell gave me that the simulation is done and the results are in the plt file, but the problem is that the differentiel potential for the Resistor R is zero !!!!
R.p=10v = R.n ????
and the R.p.i =0 !!!!!!!!!

and

and thanks in advance
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 7th December 2019 - 11:47 PM